二四六开奖结果现场直播

Hello, welcome to Shenzhen Tailianda Technology official website!

Shenzhen Tailianda Automatic Lock Screw Machine Manufacturer

Leader in industrial automatic tightening technology
Telianda National Service Hotline: 13530218024

contact us

Technical Support

Position: 二四六开奖结果现场直播 > News > Technical Support

Common faults and troubleshooting methods of hand-held screw machine

来源:原创 浏览次数:3280 Time: 2017-04-15 08:33:00 Source: Original Views: 3280

For long-term use and operation of the hand-held automatic locking screw machine , some small problems will inevitably occur. Usually these minor problems do not require a professional engineer to solve, only the basic maintenance knowledge is required.

1.Hand-held automatic lock screw machine cannot supply power normally

There are three main reasons why the hand-held automatic lock screw machine cannot supply power normally. (1) the power supply is broken, (2) the switch is broken, and (3) the DC socket is broken. These three problems can generally solve the abnormality that the screw machine cannot supply power.

2. The power light is on, but the screw machine is not working properly.

The hand-held automatic lock screw machine's power light is on, indicating that the device is normally powered. There are three main reasons why the device does not work properly:

(1) The exit sensor is not properly positioned or supported by the item;

(2) The motor power line is broken;

(3) The movable parts of the hand-held screw machine are stuck (at the eccentric wheel, at the gear);

The solution is to check for updates, re-solder, and remove foreign objects from moving parts.

3.Hand-held automatic locking screw machine

The cause of the screw problem of the material channel jam in the hand-held automatic locking screw machine is mainly the brush height, the material channel clearance, and the position of the pressure plate is not adjusted. You can check this aspect and adjust accordingly.

4. Handle automatic lock screw machine silo leaking screws

The problem of leaking screws in the silo of the handheld automatic locking screw machine is that the upper, lower, left, and right positions of the silo baffle are not adjusted, as long as the baffle is adjusted.

5.The outlet of the handheld automatic lock screw machine has been vibrating continuously

The main cause of this problem is that the feed delay of the direct vibration is too long or the position of the exit sensor is not suitable, and even the tail of the stopper is not within the sensor detection range of the automatic lock screw machine. It is also necessary to check these three places one by one and then make corresponding adjustments.

Shenzhen Tailianda Technology Co., Ltd. has continuously promoted the development of automatic locking screw machines for 15 years . The main products are handheld automatic locking screw machines, multi-axis automatic locking screw machines and online automatic locking screw machines , which are trusted by customers. To better provide technical support to customers, Telianda has set up multiple offices nationwide, including Guangdong, Zhejiang, Jiangsu, Shanghai, Hebei, Liaoning, and Chongqing. Telianda believes that the development of an enterprise is inseparable from high-quality products and perfect after-sales service.

Recommended information

Hot products

  • Qili speed automatic lock screw electromechanical batch shaft

  • Blowing type 1 two-axis automatic lock screw machine

  • Fixed double platform four axis automatic lock screw machine