二四六开奖结果现场直播

Hello, welcome to Shenzhen Tailianda Technology official website!

Shenzhen Tailianda Automatic Lock Screw Machine Manufacturer

Leader in industrial automatic tightening technology
Telianda National Service Hotline: 13530218024

contact us

Technical Support

Position: 二四六开奖结果现场直播 > News > Technical Support

Common problems and solutions of automatic lock screw machine

来源:原创 浏览次数:3468 Time: 2016-08-30 09:21:29 Source: Original Views: 3468

Automatic locking screw machine equipment is increasingly trusted by manufacturers, but there are still some faults in automatic locking screw machine, such as the following:

1. The machine is not working:

During the use of the automatic lock screw machine, the equipment is found to be operating abnormally. Generally, you can try to replace the power cord or fuse. First, check whether the power supply is normal. If the equipment is not operating normally under normal power supply, it may be a wire failure. Whether the light is on).

 

2. Automatic locking screw machine jamming;

There are many reasons for screw machine jamming. There are different solutions for different jamming failures, as shown in the following figure:

3. Sometimes there are no screws for the automatic locking screw of the screwdriver. What is the reason?

The reason that there is sometimes no electric screwdriver is mainly due to insufficient torque of the screw machine, which causes the screw not to be locked into the product to be locked normally, causing screw jamming, and insufficient screw air pressure to cause no screw output.

4. What to do with the screwdriver for electric screwdriver?

Many times, you may encounter unexpected abnormalities. What should you do when you encounter the electric batch card? In fact, it is very simple, you only need to find the corresponding fault and then solve it. Such situations as jamming generally occur in electric applicators or feeders. The reason that occurs in the feeder is more because the screw specifications do not meet the requirements. The electric screw is stuck in the electric screw due to insufficient torque, and the screw stays in the electric screw, and the next screw is blown into the electric screw, which causes the screws to squeeze each other and become stuck.


Recommended information

Hot products

  • Qili speed automatic lock screw electromechanical batch shaft

  • Blowing type 1 two-axis automatic lock screw machine

  • Fixed double platform four axis automatic lock screw machine