二四六开奖结果现场直播

Hello, welcome to Shenzhen Tailianda Technology official website!

Shenzhen Tailianda Automatic Lock Screw Machine Manufacturer

Leader in industrial automatic tightening technology
Telianda National Service Hotline: 13530218024

contact us

Technical Support

Position: 二四六开奖结果现场直播 > News > Technical Support

There are several ways to divide the material of the automatic screw machine?

来源:原创 浏览次数:3508 Time: 2016-08-19 09: 10: 55Source : Original Views: 3508

There are several ways to divide the material of the automatic screw machine ?


The automatic screwing machine is divided according to the material distribution method. There are two main forms:


1. Air blowing type: the screw is blown under the mouth of the batch through compressed air, and the electric batch is automatically locked into the product.

The blow type is generally suitable for screws below M5, the length is less than 25, and the total length L of the screw is greater than 1.3 times the diameter D of the cap diameter of the screw head.


Otherwise, a rollover phenomenon may occur in the feeding tube, and the feeding cannot be performed normally. Under normal circumstances, the automatic screw-locking machine can achieve 1S / Pcs of blowing and separating efficiency. This speed is much faster than traditional manual operation modes such as screw grabbing, moving, and screwdriver alignment.


2. Adsorption type: It is the adsorption force of the screw through the compressed air of the electric screwdriver head. Remove the single screw, and then locate it on the product hole position.

The suction type is generally suitable for screws with a relatively small length and light weight. The screw length and cap diameter ratio does not meet the requirements of the air blow type. Such screws cannot achieve air blow type transmission. At the same time, the upper surface of the screw head and the vacuum nozzle of the electric batch The cavity forms a certain air-tightness effect, so as to ensure that the screw will not fall during re-operation.
Due to the adsorption conveying method, there is a time to take the material back and forth, and the efficiency is relatively full compared to the air blowing type. The actual efficiency of the fractional material extraction is related to the walking distance and running speed, generally 1.5-4S / Pcs.


Recommended information

Hot products

  • Qili speed automatic lock screw electromechanical batch shaft

  • Blowing type 1 two-axis automatic lock screw machine

  • Fixed double platform four axis automatic lock screw machine